A Carver company - serving West Palm Beach, FL

Linear Gate Motor Repair Nationwide

Wrought ironWrought iron
Wood & steel frameWood & steel frame
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate

Linear Gate Motor Repair in West Palm Beach: What to Know First

Linear gate motor repair in West Palm Beach runs $220 to $480 for most failures, and we usually complete the job in a single visit. The repair itself is the fast part: diagnosing the actual fault is where most generalist companies burn billable hours, so we spend the first 30 minutes proving what broke before quoting anything. If you own a Linear actuator or swing operator and it’s grinding, dead, or opening halfway, call (728) 203-2413 and a live person answers.

Call (728) 203-2413

This page is for homeowners in West Palm Beach and the surrounding neighborhoods of Northwood Hills, Flamingo Park, El Cid, and Grandview Heights who have a Linear gate system and want it fixed correctly. No brand fluff. We’re an independent Linear service provider, not a factory warranty station.

How Linear Products Fail – and How We Fix Them

  • Linear LRA and LS swing operators freezing after rain events. West Palm Beach humidity works its way into the limit switch housing on these units. The switch corrodes, the board loses its position reference, and the gate either stops mid-travel or refuses to open from the keypad. We replace the limit switch, reseal the housing with a proper gasket, and test through a full cycle before leaving. Most companies replace the whole board and charge for it. That misses the cause.
  • Linear APeX and MegaCode receivers dropping remotes. When a Linear gate opens fine from the wall button but ignores the remote, homeowners assume the remote battery is dead. We see it a dozen times a year. The real issue is usually the receiver board’s antenna connection or a blown fuse on the accessory circuit. We test the receiver output at the terminal block before touching anything else, which saves the cost of a controller board you never needed.
  • Actuator arm piston leaks on older Linear swing gates. Linear’s hydraulic and mechanical swing arms do not tolerate salt air well, and West Palm Beach is salt air all day. A piston seal that lets go drops hydraulic pressure, so the gate moves slow, stalls, or shudders. We rebuild the arm with a seal kit when the cylinder bore is still true, and we tell you straight if the arm is past saving. A rebuild costs less than a replacement arm, but we won’t push a rebuild on a bore that’s scored.
  • Control board failure from lightning and power surges. West Palm Beach afternoon thunderstorms are unforgiving on gate electronics. A Linear APeX controller that worked this morning and does nothing after a storm usually has a blown MOV or a fried relay. We replace the board with an OEM-spec unit, add surge suppression where the install allows it, and the gate runs again that visit. The surge protection is the part every previous technician skipped.
  • Gearbox wear on Linear slide operators. Linear slide motors with years of service develop brass shavings in the gearbox oil, and you’ll hear a whine that gets louder over a few weeks. We don’t add more oil and call it fixed. We open the gearbox, inspect the worm and pinion, and replace what’s worn. If the gear teeth are still serviceable, fresh oil and a new seal do the job. If they’re chewed down, we quote a replacement before we order anything.
Explore

Styles & brands we work with

Wrought iron
Wrought iron
Wood & steel frame
Wood & steel frame
Farm & ranch
Farm & ranch
Sliding driveway gates
Sliding driveway gates
LiftMaster operators
LiftMaster operators

Our Linear Gate Motor Repair Process

  1. 1
    Call us at (728) 203-2413. A live person answers, takes your address and a short description of the symptom, and schedules a window. We show up in a uniform, on time.
  2. 2
    Diagnosis before estimate. Lonnie and the crew check voltage at the operator, inspect limit switches, listen to the motor, and test the receiver and loop detector if you have one. Figure out what broke first. Everything else follows from that.
  3. 3
    Written price, no surprises. We hand you a written quote before any work starts. You approve it. The number does not move.
  4. 4
    Parts decision in plain English. We use OEM or OEM-spec parts on Linear repairs by default. Where a quality aftermarket equivalent exists and saves you money, we say so and let you choose. No loyalty to a parts markup.
  5. 5
    The repair. We do the work, route wiring properly, seal connections against West Palm Beach humidity, and torque everything to spec.
  6. 6
    Test and clean up. Full open-close cycle, safety edge test, obstruction test. Then we sweep the area and walk you through what was fixed. You get the written guarantee covering the repair for 365 days.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

What Linear Gate Motor Repair Costs in West Palm Beach

Expect these ranges for typical Linear gate motor repairs in West Palm Beach:

  • Limit switch replacement: $220 – $310
  • Receiver board or remote programming fix: $180 – $260
  • Actuator arm seal or rebuild: $280 – $450
  • Control board replacement (OEM-spec): $340 – $520
  • Gearbox rebuild with new seals: $380 – $580

Then there’s the full motor replacement conversation. A new Linear swing operator installed in West Palm Beach typically runs $1,200 to $2,400 depending on the arm model and gate weight, and a slide operator lands in that same range. What moves the price: gate size, post condition, whether we’re reusing your existing photo eyes and keypad, and whether the power run or wiring needs to be brought up to code. If a repair would cost more than about 60% of replacement, we tell you that and let you decide.

Every quote is written and agreed before any work starts. Call (728) 203-2413 for a free estimate.

Why West Palm Beach Homeowners Call Carver Gate Repair West Palm Beach for Linear Work

We work on nine gate-motor brands, including LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, which means the technician at your gate has seen how one brand’s failure mode differs from another’s. A Linear swing arm fails differently than a Mighty Mule, and the fix is rarely identical. That matters when a technician is standing in your driveway deciding what to unbolt first.

Every Carver Gate Repair job runs on The Garrison Standard. Written prices before work starts. Background-checked, uniformed technicians. A written guarantee on every repair that covers 365 days, and if the repair fails inside that window, the second visit is free. No charge, no argument. Phones staffed 24/7 by a live person, including weekends and holidays. That’s the whole deal, and it applies to any repair we do in West Palm Beach.

FAQs

Need Gate Repair help in West Palm Beach? Licensed & insured · within the hour response · free estimates
Call (728) 203-2413
Local Service Coverage

Request a Free Estimate in West Palm Beach

Tell us what you need - Carver Gate Repair West Palm Beach responds fast. No obligation.

By clicking submit, you confirm you have read our Privacy Policy and authorize us to contact you through phone, text, or email concerning your request, including by the partner businesses that may perform the service.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch