Ghost Controls Gate Repair Nationwide

Ghost Controls Gate Repair in West Palm Beach: What to Know First

Ghost Controls gate repair in West Palm Beach typically runs $180 to $420 for most board, arm, and limit switch failures, with most jobs finished in a single visit. We’re an independent Ghost Controls service provider, which means we diagnose the actual fault, quote a written price before turning a wrench, and stand behind the work for a full year. This page covers the failures specific to Ghost Controls systems on West Palm Beach properties: what breaks, what it costs, and how we fix it without padding the invoice. If your gate is stuck or acting up now, call (728) 203-2413 and a live person will pick up.

Call (728) 203-2413

How Ghost Controls Products Fail – and How We Fix Them

• AXDP and HYDP arm actuator drift on the AXZL/R series. These are the articulating arm systems on a lot of West Palm Beach driveway gates. The arms lose their limit positions over time, so the gate stops short or over-travels and bangs the post. We reset limits, inspect the internal limit switch assembly, and replace the switch if it’s scored. It’s a $140 to $220 fix, not a new operator.
• Receiver board false triggers on the TSS1 and TDS1 systems. In West Palm Beach, we see moisture intrusion at the control board enclosure. The boards on these models sit in a plastic housing that was not built for Florida humidity. Corrosion across the antenna solder joints causes gates that randomly open. We clean the board, repair dry joints where possible, or install a replacement board with a sealed enclosure. Board replacement runs $160 to $290.
• Gearbox wear on the AXXV and AXXA series swing operators. These run a composite gear that strips under repeated load, especially on heavy ornamental iron gates common in Northwood Hills and El Cid. The symptom is a gate that hums but doesn’t move. We replace the gear assembly with OEM parts when the unit is under warranty, or a machined aftermarket gear when it’s out. Cost: $210 to $360 depending on the series.
• Solar systems starving the battery. Ghost Controls solar kits are popular on rural West Palm Beach properties where running AC power to the gate is expensive. But the supplied panel often can’t keep up with the number of cycles a daily-use gate sees. We diagnose whether the panel is under-sized, the battery is failing, or the charge controller has given up. Replacement batteries run $55 to $120 installed, and we will not sell you a new operator when the battery is the problem.
• Photo-eye misalignment on the safety loop. These systems use a through-beam sensor at the gate opening. When the gate shifts – and West Palm Beach’s sandy soil shifts plenty – the beam drifts out of line and the gate refuses to close. We realign the sensor and re-seat the gate. If the sensor itself is dead, replacement is $75 to $130.

Our Ghost Controls Gate Repair Process

1. 1
   You call (728) 203-2413. A live person answers – no voicemail, no call-back queue. We ask what the gate is doing, what model you have, and when the problem started.
2. 2
   We arrive with the common Ghost Controls parts on the truck. Limit switches, receiver boards, batteries, photo-eyes. That means fewer second trips, which is how we keep most jobs to one visit.
3. 3
   We diagnose before we quote. Lonnie Burke’s rule is simple: figure out what broke first. Everything else follows from that. We test voltage, inspect the arm or gear, and confirm the actual fault before any money changes hands.
4. 4
   You get a written price. Parts and labor, line by line, before work starts. The number does not move at the door.
5. 5
   We do the repair and test it. Multiple open and close cycles, safety sensor verification, and a check on the limit stops. We clean up the work area when we’re done.
6. 6
   You get the 365-Day Done Right Promise in writing. If the repair fails within a year, the second visit is free. No argument, no restocking fee, no “well, actually.”

What Ghost Controls Gate Repair Costs in West Palm Beach

Ghost Controls gate repair in West Palm Beach runs on predictable ranges, and we quote a written price before any work starts. Small electrical repairs – limit switch replacement, photo-eye realignment, battery swap – typically run $75 to $180. Control board and receiver board replacement lands between $160 and $290, depending on the model and whether we use OEM or quality aftermarket parts. Gear assembly and arm actuator work runs $210 to $360. Full operator replacement, when the unit is beyond repair, starts around $650 and goes up with the size and weight of your gate. What moves the price: the condition of the gate itself (a sagging gate exaggerates every Ghost Controls failure), whether the unit is under warranty, and how much damage the climate has already done. Call (728) 203-2413 for a free estimate – you’ll know the number before we start.

Why West Palm Beach Homeowners Call Carver Gate Repair West Palm Beach for Ghost Controls Work

Our technicians work on Ghost Controls equipment regularly, not occasionally. That matters because Ghost Controls systems have particular quirks: the limit switch tolerances, the board enclosures, the gear materials. A tech who mostly works on LiftMaster or DoorKing can spend an hour guessing. Our crew has run enough Ghost Controls diagnostics to know where to look first. We also service LiftMaster, Mighty Mule, and DoorKing, so if your property has mixed equipment – a Ghost Controls on the driveway, a Mighty Mule on a rear entry – we handle both in one call. Every technician is background-checked and uniformed. Every repair carries a written guarantee good for a full year. And every phone call is answered by a person, at any hour, including weekends and holidays. We’ve been operating to The Garrison Standard since 2008, and we follow The Garrison Code on every job: written price first, clean site, work that holds up.

FAQs